That s why we re here to help you fix the problem and get your ice back.
Kenmore refrigerator ice maker not working no water.
Make sure that the filter is in place and if it has not been changed in more than.
You buy an ice making fridge expecting it to make the ice for you not the other way around.
The most common reasons for ice maker problems are.
It makes no sense.
A faulty inlet valve may cause significant problems by delivering insufficient water.
If the refrigerator ice maker is not working the door switch might be defective.
If the ice maker is not working the water pressure in the house might be too low.
Works fine for 6 years.
Look below at the possible causes.
When there is no filter or it is clogged the ice maker does not get water.
Check the refrigerator s filter.
Of course you have to go through the following methodologies when your kenmore elite refrigerator ice maker is not working.
No water getting to ice maker.
If the door switch fails the dispenser will not turn on.
Ice makers receive water through a small water supply line that runs from the refrigerator to a water pipe funnel or a water filter.
The door switch turns off the ice and water dispenser when the refrigerator door is open.
If the kenmore ice maker is not working then a little investigating and troubleshooting may be able to alleviate the issue.
An ice maker can stop working for a variety of reasons.
If the door switch does not have continuity when activated replace it.
To determine if the door switch is defective use a multimeter to test it for continuity.
Changed water filter have hi pressure from water source to water inlet valve changed water inlet valve continuity tested same as old one at 250 ohms.
It could be the water inlet valve or the ice maker assembly low water pressure or the ice maker switch.
No frozen lines or apparent clogs.
From an ejector arm that refuses to budge to a kink in the water lines that run behind the fridge there are a few reasons that can prevent ice from dropping out of the kenmore elite s dispenser.
Water line malfunction or setting.